Removing The Fixing Pressure Roller; Fixing Delivery Paper Sensor; Removing The Fixing Assembly; Removing The Face-Up Cover - Canon MF8100 Series Service Manual

[1]
Make sure that all cables on the fixing film unit are hooked into the fixing
separation guide when reassembling the guide. Especially the right-side ca-
bles are easy to be pinched unless properly
hooked into the guide.
[1]
[2]
16) Lift the fixing film unit [1] up straight in horizontal position to take it out
of the fixing unit.
[1]

3.7.3.4 Removing the Fixing Pressure Roller

1) Remove the pressure roller[1] from the fixing unit.
[1]

3.7.4 Fixing Delivery Paper Sensor

3.7.4.1 Removing the Fixing Assembly

1) Turn the lever [1] of the fixing assembly 90 deg in the direction of the
arrow.
2) While holding the grip [2], slide out the fixing assembly [3] toward the
front and out of the machine.
Whenever you have to replace the fixing assembly, be sure to disconnect the
[2]
F-3-1030
F-3-1031
F-3-1032
F-3-1033
power cord first. Also, be sure to wait unit the fixing assembly has cooled
before removing it after disconnecting the power cord.

3.7.4.2 Removing the Face-Up Cover

1) Turn the fixing lever [1] of the fixing assembly 90 deg in the direction of
the arrow.
2) Remove the 4 claws [2], and detach the face-up cover [3] from the fixing
assembly.
[1]

3.7.5 Pre-Fixing Paper Detection Sensor

3.7.5.1 Removing the Rear Cover

1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
0011-7564
[3]
3) Open the reader assembly [4], and lift to free the 2 claws [5].
0011-7856
[1] [3] [2]
F-3-1034
[2]
[3]
F-3-1035
[1]
[2]
F-3-1036
Chapter 3
[1]
0011-7857
[1]
0007-8885
[3]
3-159