Searching And Setting Parameters - Toshiba TOSVERT VF-AS1 Instruction Manual

4. Searching and setting parameters

There are two types of setting mode quick mode and standard setting mode.
Quick mode
Standard setting mode
For reasons of safety, the following parameters have been set up so that they cannot be reprogrammed while the
inverter is running.
[Basic parameters]

(Automatic acceleration/deceleration)

(Automatic torque boost)

(Automatic function setting)

(Command mode selection)

(Frequency setting mode selection 1)

(V/f control mode selection)

(Base frequency 1)

(Base frequency voltage 1)

(Maximum frequency)

(Auto-restart control selection)

(Regenerative power ride-through control)

(Dynamic braking selection)

(Dynamic braking resistance)
 (Allowable continuous braking resistance)

(Factory default setting)
⇒ To write-protect extended parameters during operation, refer to Section 11.
: EASY key: ON
Eight frequently used basic parameters are just
displayed (Factory default position).
Quick mode (EASY)
Title








Parameters you selected can be displayed by changing
the parameter. (Up to 32 parameters)
: EASY key: OFF
Both basic and extended all parameters are displayed.
Basic parameters
Extended parameters
D-1
Function
Automatic function setting
V/f control mode selection
Maximum frequency
Acceleration time 1
Deceleration time 1
Motor electronic thermal protection level 1
FM terminal meter adjustment
Registered parameter display selection
: This parameter is a basic parameter for the
operation of the inverter.
⇒ For details of basic parameters, refer to Section 5.
⇒ For parameter settings, refer to Section 11.
:The parameters for detailed and special
setting.
⇒ For details of extended parameters, refer to Section 6.
⇒ For parameter settings, refer to Section 11.
E6581528
4