Setting Frequency Via External Contact Input (Up/Down Frequency Setting - Toshiba TOSVERT VF-AS1 Instruction Manual

[Setting of jog run setting terminal (S3-CC)]
Assign control terminal S3 ([: preset speed 3] in default setting) as the jog run setting terminal.
Title

Note: During the jog run mode, there is LOW (low speed detection signal) output but no RCH (designated frequency
reach signal) output, and PID control does not work.
•When the inverter is in panel jog mode, pressing the
•When  is displayed, the inverter will be placed in forward jog run mode as long as the
•When  is displayed, the inverter will be placed in reverse jog run mode as long as the
•During jog run, the direction of rotation can be changed using the
motor in the forward direction, or press the
•If you press and hold down the
The figure below shows the relationship between the operation panel jog run mode and each of the other modes.
Pressing the
6
Note1: When the inverter is in operation (RUN key lamp is lit) or when an operation command is issued (RUN key
lamp is lit), the inverter cannot be switched to operation panel jog run mode.
Note 2: When parameter  (input terminal priority selection) is set to  , the inverter does not display any
message saying that it is in panel jog run mode.
6.11

Setting frequency via external contact input (Up/Down frequency setting)

 : Input from external contacts - Up response time
 : Input from external contacts - Up frequency step
 : Input from external contacts - Down response time
 : Input from external contacts - Down frequency step
 : Initial Up/Down frequency
 : Initial Up/Down frequency rewriting
• Function
These parameters are used to set the output frequency by means of a contact signal from the external
control device.
[Parameter setting]
Title
 Input from external contacts - Up response time
 Input from external contacts - Up frequency step
 Input from external contacts - Down response time
 Input from external contacts - Down frequency step
 Initial Up/Down frequency
 Initial Up/Down frequency rewriting
These functions are operative when parameter  (frequency setting mode selection 1) is set to  or
parameter  (frequency setting mode selection 2) is set to .
Function
Input terminal function selection 7 (S3)
RUN
key for 20 seconds or more, the key failure alarm "" will be displayed.
key, which will move the inverter through each of the modes.
MODE
MODE
Status monitor mode
MODE
Function
Adjustment range
~
key displays , while pressing the
and
key to run it in the reverse direction.
Status monitor mode
MODE
Status monitor mode
Operation panel
jog run mode
Adjustment range
 ~ s
 ~  Hz
 ~ s
 ~  Hz
~ Hz
:Not changed
:Setting of  changed
when power is turned off.
F-20
E6581528
Example of setting
 (Jog run setting terminal)
key displays .
RUN key is held down.
key is held down.
RUN
keys. Press the key to run the
MODE
Default setting





