Toshiba TOSVERT VF-AS1 Instruction Manual page 54

[Standard connection diagram - source logic]
The figure below shows an example of typical wiring in the main circuit VFAS1-6400KPC to 6630KPC inverter.
Main circuit power source
400~630kW
690V class :
Three-phase 500~690V-50/60Hz
b-contact of
overload relay
*1: AC reactor (PFL): Mandatory for VFAS1-6110KPC and above.
*2: Transformer for fan supply (TRS) ⇒Refer to section 1.4.4.
*3: ⇒ Refer to Section 2.3.2 for switch functions.
*4: The functions assigned to terminals OUT1, VI/II and RR/S4 can be switched by changing parameter settings.
⇒ For details refer to Section 2.3.2.
*5: To supply control power from an external power supply for backing up the control power supplied from the inverter, an
optional control power backup device (CPS002Z) is required. In such a case, the backup device is used at the same time
with the internal power supply of the inverter.
To back up control power, set the parameter  (Control power supply backup option failure monitoring) properly.
⇒ For more information, refer to 6.33.24.
*6: For PWR connection conforming to safety standards, refer to Section 9.3.
*7: If you use a braking unit (optional) and external braking resister (optional) in combination.
*8: TRS(Transformer for fan power supply) can not be used this system for VFAS1-6110KPC and above.
*2
TRS
X0
Transformer for
Fan power Supply
X2
*1
PFL
NOISE
Filter
NOISE
Filter
Transformer
down to 200V
Control power supply
backup (Option) *5
Surge
suppressor
From (a)
*4
(a)
Frequency
Ammeter
meter
Ammeter or voltmeter
B-9
*2
*7
*2
Rectifi
cation
circuit
Main
circuit
Rectifi
cation
circuit
Fan
Control
(a)
circuit
*6
*3
*4 *4
(a)
Voltage signal:-10~+10V
(a)
Voltage signal:0~10V
or current signal:4 (0)~20mA
(a)
External potentiometer
(or voltage signal between RR/S4 and CCA:0~10V)
E6581528
*7
Motor
Forward run signal
Reverse run signal
Reset
Preset speed 1
Preset speed 2
Preset speed 3
2