Setting/Monitor Modes; Status Monitor Mode - Toshiba TOSVERT VF-AS1 Instruction Manual

3.1

Setting/monitor modes

The VF-AS1 has the following three setting/monitor modes.
Standard monitor mode
3
Setting monitor mode The mode for setting inverter parameters.

Status monitor mode

Pressing the key MODE will move the inverter through each of the modes.
Monitoring of
operation status
⇒ Refer to
Section 8.1.
The standard inverter mode. This mode is enabled
when inverter power goes on.
This mode is for monitoring the output frequency and setting the frequency reference value. If also
displays information about status alarms during running and trips.
• Setting frequency reference values ⇒ Refer to Section 3.2.
• Status alarm
If there is an error in the inverter, the alarm signal and the frequency will flash alternately in
the LED display.
: When a current flows at or higher than the overcurrent stall prevention level.
: When a voltage is generated at or higher than the over voltage stall prevention level.
: When the cumulative amount of overload reaches 50% or more of the overload trip
value.
: When temperature inside the inverter rises above overheating protection alarm level
(about 95°C)
⇒ How to set parameters, refer to Section 4. 1.
This mode is divided into two modes according to the parameter readout mode
selected.
Quick mode
Standard setting mode :Both basic and extended all parameters are displayed.
The mode for monitoring all inverter status.
Allows monitoring of set frequencies, output current/voltage and terminal
information.
⇒ Refer to Section 8.
Standard monitor mode
(when the power is turned on)
Status monitor mode
:Eight frequently used basic parameters are just displayed.
The maximum 32 parameters that you select by
yourselves are displayed.
Setting monitor mode
C-2
E6581528
How to search and set
parameters
⇒ Refer to Section 4.1.