Trunk Configuration Screen For Switch S3; Figure 1-44. Multilink Trunk Configuration Screen For Switch S3 - Nortel BayStack 410 24T Using Manual

Trunk Configuration Screen for Switch S3

As shown in
configuration (T4). This trunk connects directly to switch S1.
As in the previous screen examples, to set up an inter-switch trunk configuration
choose MultiLink Trunk Configuration from the MultiLink Trunk Configuration
Menu screen.
Figure 1-44
Trunk Trunk Members (Unit/Port)
----- ------------------------------- ------------ --------------- ------------
1 [ /1 ][
2 [ / ][
3 [ / ][
4 [ / ][
5 [ / ][
6 [ / ][
Trunk Trunk Name
----- ------------------
1 [ S3:T4 to S1 ]
2 [ Trunk #2 ]
3 [ Trunk #3 ]
4 [ Trunk #4 ]
5 [ Trunk #5 ]
6 [ Trunk #6 ]
Enter text, press <Return> or <Enter> when complete.
Press Ctrl-R to return to previous menu.
Figure 1-44. MultiLink Trunk Configuration Screen for Switch S3
Switch S3 is configured as follows:
•
•
309985-B Rev 00
Figure 1-40
shows the MultiLink Trunk Configuration screen for switch S3.
MultiLink Trunk Configuration
/3 ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
/ ][ / ][ /
Trunk (read only) indicates the trunk (1 to 6) that corresponds to the switch
ports specified in the Trunk Members fields.
Trunk Members (Unit/Port) indicates the ports that can be configured, in
each row, to create the corresponding trunk:
Ports 1 and 3 are assigned as trunk members of trunk 1.
Introduction to the BayStack 410-24T Switch
on page 1-63, switch S3 is set up with one trunk
STP Learning
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Normal ]
Press Ctrl-C to return to Main Menu.
Trunk Mode Trunk Status
Basic [ Enabled
Basic [ Disabled ]
Basic [ Disabled ]
Basic [ Disabled ]
Basic [ Disabled ]
Basic [ Disabled ]
]
1-69