Logout - Nortel BayStack 410 24T Using Manual

Logout

The Logout option (accessed from the main menu) allows a user working at a
password-protected console terminal or in an active TELNET session to terminate
the session.
The Logout option works as follows:
•
•
BayStack Model 410-24T HW:Revx FW:Vx.xx SW:Vx.x.x.x
Figure 3-53.
You can specify whether a password is required for the TELNET session or the
console terminal using the Console/Comm Port Configuration screen (see
"Console/Comm Port
If the console terminal is not password protected, the system ignores the Logout
option.
309985-B Rev 00
If you are accessing the BayStack 410-24T switch through a TELNET
session, the Logout option terminates the TELNET session.
If you are accessing the BayStack 410-24T switch through a
password-protected console terminal (connected to the console/comm port on
the switch), the Logout option displays the console-terminal password prompt
(Figure 3-53). If RADIUS authentication is enabled, the password field is
preceded by a username field. You must enter the correct password (and
username, if applicable) to access the CI screens.
Password:
Enter Password:
Password Prompt Screen
Configuration" on
[ *************** ]
page 3-82).
Using the Console Interface
3-117