Nortel BayStack 410 24T Using Manual page 193

Choose High Speed Flow Control Configuration (or press h) from the Switch
Configuration Menu screen to open the High Speed Flow Control Configuration
screen.
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu.
Figure 3-23. High Speed Flow Control Configuration Screen
Table 3-20
Table 3-20. High Speed Flow Control Configuration Screen Fields
Field
Unit
Autonegotiation
309985-B Rev 00
High Speed Flow Control Configuration
Unit:
Autonegotiation:
Flow Control:
Preferred Phy:
Active Phy:
describes the High Speed Flow Control Configuration screen fields.
Description
Allows you to select the unit number (when stacking is configured) to view or
configure. To view or configure another unit, type its unit number and press
[Enter], or press the spacebar to toggle the unit numbers (the system only
displays a screen for units that are configured with a gigabit MDA).
When enabled, the port only advertises support for 1000 Mb/s operation, in
full-duplex mode.
Default Value Enabled
Range Enabled, Disabled
Using the Console Interface
[ 2 ]
[ Enabled ]
[ Disabled ]
[ Right ]
None
Press Ctrl-C to return to Main Menu.
(continued)
3-55