Nortel BayStack 410 24T Using Manual page 136

Using the BayStack 410-24T 10BASE-T Switch
Select IP Configuration/Setup (or press i) from the Main Menu.
4.
This selection displays the IP Configuration/Setup screen
Note: The default management VLAN (IP interface) for the BayStack
410-24T switch is VLAN 1. However, you can specify which VLAN you want
to be the management VLAN (see "VLAN Configuration" on page 3-40).
In-Band Stack IP Address:
In-Band Switch IP Address: [ 0.0.0.0 ]
In-Band Subnet Mask:
Default Gateway:
IP Address to Ping:
Start Ping:
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu.
Figure 2-17. IP Configuration/Setup Screen (Stack Configuration)
Enter the Stack IP address in the In-Band Stack IP Address field, then
5.
press [Return].
The In-Band Switch IP Address field (directly below the In-Band Stack IP
Address field) is not required for the operation of the stack. The In-Band
Switch IP Address field allows this switch to operate as a standalone switch.
Both IP address fields cannot be configured to use the same IP address.
2-22
IP Configuration/Setup
BootP Request Mode:
Configurable
-------------------
[ 0.0.0.0 ]
[ 0.0.0.0 ]
[ 0.0.0.0 ]
[ 0.0.0.0 ]
[ No ]
[ BootP Disabled
In Use
---------------
0.0.0.0
0.0.0.0
Press Ctrl-C to return to Main Menu.
(Figure 2-17).
]
Last BootP
---------------
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
309985-B Rev 00