Nortel BayStack 410 24T Using Manual page 242

Using the BayStack 410-24T 10BASE-T Switch
Table 3-37. Software Download Screen Fields
Field Description
TFTP Server IP The IP address of your TFTP load host.
Address
Default Value
Range
Start TFTP Load Specifies whether to start the download of the switch software image (default is No).
of New Image
Use the spacebar to toggle the selection to Yes.
Press [Enter] to initiate the software download process.
Note:
if the load host path is congested or there is a high volume of network traffic).
To ensure that the download process is not interrupted, do not power down the switch for
approximately 10 minutes.
Default Value
Range
LED Indications During the Download Process
The software download process automatically completes without user
intervention. The process erases the contents of flash memory and replaces it with
a new software image. Be careful not to interrupt the download process until after
it runs to completion (the process could take up to 10 minutes for completion,
depending on network conditions).
Note: If problems occur during the software download process, the Software
Download screen displays error codes that define the problem. The error codes
are described in Chapter 4, "Troubleshooting."
When the download process is complete, the switch automatically resets and the
new software image initiates a self-test. The BayStack 410-24T switch Self-Test
screen (see Figure 2-11 on page 2-15) briefly displays the results and is followed
by the Nortel Networks logo screen. Press [Ctrl]-Y from the Nortel Networks logo
screen to access the BayStack 410-24T switch main menu.
3-104
0.0.0.0 (no IP address assigned)
Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, separated by a decimal point
The software download process can take up to 60 seconds to complete (or more
No
Yes, No
(continued)
309985-B Rev 00