Nortel BayStack 410 24T Using Manual page 238

Using the BayStack 410-24T 10BASE-T Switch
Table 3-36. TELNET Configuration Screen Fields
Field Description
TELNET Access Allows remote access to the CI through a TELNET session.
Default Value:
Range:
Login Timeout Specifies the amount of time you have to enter the correct password at the
console-terminal prompt.
Default Value:
Range:
Specifies the number of times you can enter an incorrect password at the
Login Retries
console-terminal prompt before the session is terminated.
Default Value:
Range:
Inactivity Specifies the amount of time the session can be inactive before it is terminated.
Timeout
Default Value:
Range:
Event Logging Specifies the types of events that will be displayed in the Event Log screen (see
Event
Default Value:
Range:
Description:
3-100
Enabled
Enabled, Disabled
1 minute
0 to 10 minutes (0 indicates "no timeout")
3
1 to 100
15 minutes
0 to 60 minutes (0 indicates "no timeout")
Log" on page 3-109).
All
All, None, Accesses, Failures
All: Logs the following TELNET events to the Event Log screen:
• TELNET connect: Indicates the IP address and access mode of a
TELNET session.
• TELNET disconnect: Indicates the IP address of the remote host
and the access mode, due to either a logout or inactivity.
• Failed TELNET connection attempts: Indicates the IP address of
the remote host whose IP address is not on the list of allowed
addresses, or indicates the IP address of the remote host that did
not supply the correct password.
None: Indicates that no TELNET events will be logged in the Event
Log screen.
Accesses: Logs only TELNET connect and disconnect events in the
Event Log screen.
Failures: Logs only failed TELNET connection attempts in the Event
Log screen.
"Display
(continued)
309985-B Rev 00