Controls; Fuel Cock (Tc-Txc); Fuel Injection Engine (Te-Smr) - Husqvarna TE 250-450-510/2008-I.E. Owner's Manual

Table of Contents

Available languages

CONTROLS

The left-side tap (2) is a screw tap: screw the ring nut (A) to

close the tap, loosen the ring nut to open the tap.

WARNING*: Be careful not to touch the hot

engine while operating the fuel valve.

A fuel filter is incorporated in the fuel valves. Accumulation of

dirt in the filter will restrict the flow of the fuel to the carbure-

tor. Therefore, the fuel filter should be serviced periodically.

1 Loosen the input plug (1) on the fuel tank and close the tap;

2 Remove the fuel hose (3) from the carburetor and insert the

hose in a vessel;

3 Open the tap and drain the fuel out of the tank;

4 Remove the fuel valve by removing the screws. Wash the fuel

screen filter in cleaning solvent;

5 Reassemble the fuel valve in the reverse order of removal.

Open the tap and check for leaks.

On vehicles which are fitted with a fuel injection engine, the

fuel pump is built into the fuel tank and there is no tap mount-

ed on the fuel supply system. The quantity of remaining fuel is

indicated on the digital dash-board by the special warning

light (see on page 16).

1. Fuel tank cap

2. Fuel cock

3. Fuel hose

A. Tap ring nut