Exhaust Muffler; Replacing The Muffler Deadening Material - Husqvarna TE 250-450-510/2008-I.E. Owner's Manual

Table of Contents

Available languages

EXHAUST MUFFLER

The muffler reduces the noise of the exhaust gases, but it is an

integral part of the exhaust as well. As such, its conditions af-

fect the motorcycle performance.

When the noise on the exhaust is too high, it means that the

deadening material set on the holed tube inside the muffler is

deteriorated.

WARNING: Check the deadening material af-

ter every competition and replace it if neces-

First turn counterclockwise fastening rear pin (1) then remove

saddle, screws (2) and L.H. side panel (3). Using an 8 mm T-

shaped spanner on the outside and a 10 mm T-shaped spanner

on the inside, remove the locking screw (4) of the muffler.

Remove the spring (5) and with an 8 mm T-shaped spanner re-

move the screw (8); then pull out the muffler.

Remove the six rear rivets (6), clamp and the exhaust terminal

(7). Remove innner pipe and replace the deadening material.

Reassemble L.H. side panel and saddle.

NOTE: When diffuculties are found in remov-

ing the muffler, lightly beat with a rubber

or plastic hammer.