Checking The Oil Level; Engine Oil Replacement And Bag Filters - Husqvarna TE 250-450-510/2008-I.E. Owner's Manual

Table of Contents

Available languages

CHECKING THE OIL LEVEL

Keeping the motorbike level and in a vertical position, check the

oil level through the inspection (1) window on the right

crankcase. Make sure the level is in between the MIN and MAX

To fill up, remove the filler cap (2).

Note*: Have this operation made with

warmed-up engine.

WARNING*: Be careful not to touch hot en-

ENGINE OIL REPLACEMENT AND BAG FILTERS-FIL-

TER CARTRIDGE CLEANING OR REPLACEMENT

WARNING*: Be careful not to touch hot en-

Drain the oil with WARM ENGINE; proceed as follows:

- remove oil filler cap (1);

- remove the engine guard (A)

- place an oil drain pan under the engine block

- remove the oil drain cap (2)

- drain the used oil completely then clean the magneto on the

- remove the three filters (4), (5) and (6) on the L.H. side of

the engine, check O-Rings for wear then clean filters with fu-

el; reassemble using the reverse procedure;

- in order to replace the filter cartridge (3), unscrew the three

fastening screws then the filter cartridge cover;

- after filters replacement, reassemble the drain cap (2), the

engine guard (A) then pour the recommended oil quantity.