Engine Start (Te-Smr) - Husqvarna TE 250-450-510/2008-I.E. Owner's Manual

Table of Contents

Available languages

ENGINE START (TE-SMR)

With cold engine, as after a prolonged inactivity of the motor-

cycle or in presence of a low external temperature, proceed as

1) set ignition key (1) in IGNITION position (the buzz that you

hear when you turn the key to IGNITION is caused by the

fuel pump which puts the feeding system under pressure);

2) pull the starter lever (2);

3) pull the clutch lever (3);

4) shift gear pedal (4) in neutral position then release the

clutch control lever;

5) press the engine start-stop switch (5) then the start button

Put the start lever (2) in its initial position as soon as the en-

gine is idling. When starting with an already warmed up en-

gine DO NOT USE the starter. When a cold engine has just been

started, do not increase revs, to ensure an

adequate oil warm-up and circulation.

A safety switch is set on the clutch lever support. This switch al-

lows you ONLY to start the engine with idle gearbox, or with

the gear engaged and the clutch lever pulled.

NEVER START WITH DISCONNECTED BATTERY.