Husqvarna TE 250-450-510/2008-I.E. Owner's Manual page 165

Table of Contents

Available languages

- Pump with brake lever (3) or brake pedal (3A) in order to

push brake fluid out of line.

- Close the bleeding valve and fill the reservoir with fresh

brake fluid.

- Open the bleeding valve, apply the brake using the brake

lever or pedal, close the bleeding valve with the brake lever

or pedal applied and then quickly release the lever or pedal.

- Repeat this operation until the brake line is filled and clear

fluid starts coming out of the plastic hose: now close the

bleeding valve.

- Restore the brake fluid level (A) or (B) then reassemble the

rubber and the fluid reservoir cap (page 62).

After the brake fluid replacement, it is necessary to operate

the braking system bleeding (see pages 64 and 65).