Initial Value Change List - Mitsubishi Electric FR-E700 Instruction Manual

4.25 Initial value change list

Displays and sets the parameters changed from the initial value.
Operation
1.
Screen at powering ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until
5.
Pressing
change list screen.
6.
Turning displays the parameter number
changed.
Press to read the currently set value.
Turn and press
setting
(refer to step 6 and 7 on page 53)
Turn to read another parameter.
The display returns to
parameters are displayed.
7.
Pressing
the parameter setting mode.
Turning
Pressing
NOTE
Calibration parameters (C1 (Pr. 901) to C7 (Pr. 905)) are not displayed even they are changed from the initial settings.
Only simple mode parameter is displayed when simple mode is set (Pr. 160 = 9999)
Only user group is displayed when user group is set (Pr. 160 = "1").
Pr. 160 is displayed independently of whether the setting value is changed or not.
When parameter setting is changed after creating the initial value change list, the setting will be reflected to the initial
value change list next time.
Parameters referred to
Pr. 160 User group read selection
C1 (Pr. 901) AM terminal calibration
C2(Pr. 902) to C7(Pr. 905) (Frequency setting bias/gain parameter)
appears.
changes to the initial value
to change the
after all
in status returns to
sets other parameters.
displays the change list again.
Refer to page 179
Refer to page 151

Initial value change list

Display
PU indication is lit.
PRM indication is lit.
(The parameter number read previously
appears.)
* It may take several seconds
for creating the initial value
change
flickers while creating the list.
Flicker Parameter setting complete!!
Refer to page 170
"
list. "
263
4