Replacing Staples (For C3 Finisher Or C3 Finisher With Booklet Maker) - Fuji Xerox ApeosPort-V C7785 Administrator's Manual

3 Maintenance

Replacing Staples (for C3 Finisher or C3 Finisher with Booklet Maker)

When the C3 Finisher (optional) or the C3 Finisher with Booklet Maker (optional) is installed
and the staple cartridge needs to be replaced, a message appears on the touch screen.
When this message appears, load a new staple case into the staple cartridge.
The Staple Cartridge [R1] is running out of
staples.
Check the Staple Cartridge [R1] and order
staples.
The Staple Cartridge [R1] is out of staples or not
fully inserted.
Check the Staple Cartridge [R1].
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Note
3
1
Make sure that the machine is not operating,
and open the finisher front door.
2
With grasping the lever [R1] of the staple
cartridge holder, pull the holder to the right,
towards you.
82
Message
Use only staple cartridges recommended by Fuji Xerox.
• If the staple cartridge was not replaced properly, the message remains on the touch screen. Follow
the procedure and replace the staple cartridge again.
• The 50 sheets staple cartridge is installed as standard in C3 Finisher or C3 Finisher with Booklet
Marker. When you install the C3 Finisher Staple Unit 65 Sheets (optional) remove the 50 sheets
staple cartridge. After removing the 50 sheets staple cartridge, be sure to keep it.
• The 50 sheets staple cartridge cannot be set to the C3 Finisher Staple Unit 65 Sheets (optional). If
you use the C3 Finisher Staple Unit 65 Sheets (optional), order the staple cartridge for 65 sheets
staple.
• To check the type of staples that you are using, refer to "Supplies" (P.123).
• To order a staple cartridge, contact our Customer Support Center.
Solution
Prepare new staples.
Note • Staples cannot be replaced yet.
Replace staples with new ones.