Fuji Xerox ApeosPort-V C7785 Administrator's Manual page 219

 Server Response Time-Out
Set the server time-out response between 1 and 75 seconds in 1 second increments.
 Search Time-Out
Set the user information search time-out between 1 and 120 seconds in 1 second
increments.
Kerberos Server Settings (ApeosPort Series Models Only)
Configure the Kerberos Servers 1 to 5.
The settings in [Kerberos Server 1 (Default)] will be the default settings for authentication.
 Primary Server Name/Address
Enter the primary server name or IP address.
Note
 Primary Server - Port Number
Set the primary server port number from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
 Secondary Server Name/Address
Enter the secondary server name or IP address.
Note
 Secondary Server - Port Number
Set the secondary server port number in the range from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
 Domain Name
When you use Active Directory of Windows 2000 Server, Windows Server
Server 2008 or Windows Server 2012 as server, specify the domain name of Active Directory
in [Domain Name]. Up to 64 characters are allowed.
Important • Enter a realm name in uppercase characters. Otherwise, an authentication error occurs.
 Server Certificate Verification
Select whether or not to verify a server certificate.
LDAP Server/Directory Service Settings (ApeosPort Series Models Only)
Configure the directory server, authentication method, and search attributes and ranges for
LDAP authentication and the Address Book search by LDAP.
You can check the connection to the server by selecting [Connection Test]. Selecting
[Connection Test] > [LDAP Communication Report] outputs the report that shows the
contents of protocol of the LDAP communication transmitted and received by the machine.
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
Connectivity & Network Setup
®
2003, Windows
219
5