Original size
Selects the paper size that is specified with the application software. The initial setting is [A4].
The following paper sizes can be selected.
A3W A3 A4 B4 B5 B6 Postcard Foolscap Legal Letter Tabloid Statement Custom / Custom size 1-20 (*)
* Paper sizes that have been registered in advance with [Controller setting 2] in [Administrator] of RISO Console PS7R are dis-
played.
• If you use frequently irregular sizes, register the sizes in advance. These sizes can be easily selected from the pull-down menu. The
registered paper sizes are also displayed as [Output Paper Size].
"Controller setting 2" of "HC5500 User's Manual for Console"2-18
• If you do not register the size and you specify each time, use the following procedure.
1. Select [Custom] at [Original size] and click the [Custom Paper Entry] button.
2. Input the paper size*.
Width: 90mm to 316mm (3
Length: 148mm to 460mm(5
3. Close the printer driver screen.
4. Start the application software for creating the original.
5. Select [Postscript Custom Paper Size] at [Size] of [Page Set up].
The original size selected in step 2 is reflected and the original can be created with the size proper for this machine.
HC5500 connected with PS7R is a PS printer. Although the setting in the application software normally takes precedence, if an orig-
inal is created for a non-standard size, the [Original size] must be input in the HC5500 printer driver in advance and therefore the
steps are different from the normal procedure.
* When a finisher is connected to the printer, usable paper sizes vary according to the model of finisher. See below.
Output paper size
Selects the paper size for printing. The initial setting is [Same as original].
The following paper sizes can be selected.
Same as original A3W(*1) A3 A4 B4 B5 B6 Postcard Foolscap Legal Letter Tabloid Statement Custom
/ Custom size 1-20 (*2)
*1 The A3W size is 316 mm (W) x 460 mm (L).
*2 Paper sizes that have been registered in advance with [Controller setting 2] in [Administrator] of RISO Console PS7R are dis-
played.
If [Zoom] is not set (not checked), for an original size different from the output paper size, enlargement/reduction is automatically
performed according to the output paper size.
If you use frequently irregular sizes or if you specify an irregular size each time, use the same operation as [Original Size]
described above.
When a finisher is connected to the printer, usable paper sizes vary according to the model of finisher.
HC Finisher: width 100mm-316mm length 148mm-460mm
HC Auto Stacker: width 100mm-305mm length 148mm-432mm
Zoom
Specifies the enlargementreduction ratio for printing in .
If you click [Zoom] to display a check mark, you can specify the enlargementreduction ratio from 50 to 200 .
The initial setting is off.
If [Pagination] is set to any of [Multi-up (Single page)], [Multi-up (Multi-page)], [Booklet], and [Fold], Zoom cannot be specified.
3-12
9
7
/
" to 12
/
")
16
16
13
1
/
" to 18
/
")
16
8