Synchronizing With The Server; Manual Synchronization - Symbol MC909X Integrator Manual

Misc (3) Tab
Figure 7-26
Field
Use DHCP This check box control specifies whether the AirBEAM Smart Client uses the DHCP
server response option 66 to specify the IP address of the FTP/TFTP server.
If enabled, special RF network registry settings are required to force the DHCP server to
return the "TFTP server name" field (option 66). The special RF network registry settings are
included, but commented out, in the radio network registry initialization files
(essid_xxxx_yy.reg).
Use DHCP This check box control specifies whether the AirBEAM Smart Client uses the DHCP
bootfile response option 67 to specify the Package and Package 1 parameters.
If enabled, special RF network registry settings are required to force the DHCP server to
return the "Bootfile name" field (option 67). The special RF network registry settings are
included, but commented out, in the radio network registry initialization files
(essid_xxxx_yy.reg).

Synchronizing with the Server

When the synchronization process is initiated, the AirBEAM Smart Client attempts to open an FTP session
using the AirBEAM Smart Client configuration. Once connected, the client processes the specified packages.
Packages are loaded only if the server version of a given package is different from the version loaded on the
client. Once the upload process is complete, the AirBEAM Smart Client closes the FTP session with the server.
The AirBEAM Smart Client can launch an FTP session with the server either manually, when initiated by the
user, or automatically.

Manual Synchronization

Configure the AirBEAM Smart Client. See
1.
From the main AirBEAM CE window, tap File - Synchronize.
2.
Once connected, the AirBEAM Synchronize window appears.
3.
AirBEAM Synchronize Window
Figure 7-27
Application Deployment for WinCE 5.0 7 - 33
Description
Configuring the AirBEAM Smart Client on page 7-28.