Canon iR5000 Service Manual page 772

CONFIG
Use it to select multiple pieces of firmware retained on the hard disk so as
to make appropriate settings: country, language, model, paper size series.
Settings XXYYZZAA XX: country (JP), YY: language (ja), ZZ (00); model,
AA (00): paper size series; display will be in the following sequence and
the parentheses indicate default settings:
COPIER>DISPLAY>USER>LANGUAGE.
Using the Mode
1) Select CONFIG.
2) Select an item (to highlight), and press the +/- key to scan through
the items.
3) When the appropriate setting has appeared for each item, press the
OK key.
WARM-UP
Use it to reduce the warm-up time if the room temperature is likely to be
about 18°C or higher when the machine is first turned on.
In the case of the iR5000 Series, the multiple rotation initial, standby, and
print start temperatures are reduced by 15°C.
In the case of the iR6000 Series (100-V model), the period of initial mul-
tiple rotation is reduced by 1 min.
Caution • For the 120/230-V model, the same control mechanism is used for both
• This mode is disabled if FSPD-S1 is set.
Settings 0: standard (default), 1: reduced mode (as above)
SHARP
Use it to change the sharpness level of the image.
• A higher setting makes the images sharper.
Settings 1 to 5 (default: 3)
LAPC-SW
Use it to switch laser APC correction.
Settings 0: ON (initial rotation APC executed if left alone for 10 min), 1: ON
(initial rotation ON APC executed if left alone for 60 min; default),
2: (initial rotation APC executed if left alone for 120 min)
3: initial rotation APC only off; 4: OFF
FDW-DLV
Use it to switch face-up delivery to ensure stacking performance when mak-
ing multiple prints.
Settings 0: normal (all in face-up delivery, if single original; default)
1: face-up delivery for single print of single original, face-down deliv-
ery for multiple prints)
COPYRIGHT © 2000 CANON INC.
iR6000 Series and iR5000 Series.
2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000
CHAPTER 5 SERVICE MODE
COPIER>OPTION
5-79 T