Canon iR5000 Service Manual page 294

2) Tighten the five mounting screws [2]
lightly, stopping to turn them when re-
sistance is felt.
3) Turn the screws tightened lightly in step
2) about 20° to 30° in the order indi-
cated, tightening them fully.
After mounting the cleaning
blade, check to make sure that
the edge of the blade is not ap-
preciably bent.
Further, be sure to clean the
groove in the blade support
plate before mounting the blade,
as toner or the like in the groove
can start to bend the blade.
COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000
CHAPTER 4 IMAGE FORMATION SYSTEM
[2]
5 3
F04-711-07
1 2 4
Order of tightening
4-81 P