Canon iR5000 Service Manual page 753

CHAPTER 5 SERVICE MODE
<INSTALL>
Modes for Installation
TONER-S
Use it to supply toner from the hopper to the developing assembly and to
stir the toner inside the developing assembly.
Caution • Make sure that the developing assembly is properly mounted before
• Do NOT turn off the power while the machine is in operation.
Using the Mode
1) Select the mode item, and press the OK key.
2) The machine executes toner supply. (about 8 to 10 min)
• While toner is being supplied, the duration (sec) is counted down start-
3) The machine stops automatically at the end of the operation.
STRD-POS
Use it to execute auto adjustment of the position of the CCD read position
for stream reading mode.
Caution • Execute this mode at time of installing an ADF or if you have removed
Using the Mode
1) Select this item, and press the OK key.
• Auto adjustment is executed.
2) See that the adjustment ends automatically.
3) Record the updated setting indicated in service mode on the service
label: COPIER>ADJUST>ADJ-XY>STRD-POS.
5-60 T
pressing the OK key.
ing at '600 sec'.
and then installed the existing ADF.
COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000
COPIER>FUNCTION