Canon iR5000 Service Manual page 811

CHAPTER 6 SELF DIAGNOSIS
1.3 Self Diagnosis of the Finisher
E500
Main Cause The finisher controller PCB is faulty. The DC controller PCB is faulty.
Mode of
Detection
0001 The communication between the host machine and the finisher has
E503
Main Cause The saddle stitcher controller PCB is faulty. The finisher controller PCB is
faulty.
Mode of
Detection
0002 The communication between the saddle stitcher controller PCB
E504
Main Cause The height sensor (PS1) is faulty. The finisher controller PCB is faulty.
Mode of
Detection
0001 Communication between the height sensor and the finisher control-
0002 Communication between the height sensor and the finisher control-
0003 At time of power-on, the connector of the height sensor is found to
0004 When the height sensor is being adjusted using the DIP switch, an
E505
Main Cause The EEPROM is faulty. The finisher controller PCB is faulty. The puncher
driver PCB is faulty.
Mode of
Detection
0001 When the power switch is turned on, the check sum of the
0002 When the power switch is turned on, the check sum of the
6-14 T
been interrupted; this error is detected by the host machine.
and the finisher controller PCB has been interrupted.
ler PCB is not possible, or communication data has an error.
ler PCB is not possible for a specific period of time.
be disconnected.
error occurred during the adjustment.
EEPROM on the finisher controller PCB is found to have an error.
EEPROM on the puncher driver PCB is found to have an error.
COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000