Canon iR5000 Service Manual page 273

CHAPTER 4 IMAGE FORMATION SYSTEM
6) Insert the door switch actuator into the
door switch assembly.
7) Connect the power plug to the power
outlet, and turn on the main power
switch.
8) Execute the following in service mode:
COPIER>FUNCTION>DPC>OFST.
9) Record the setting of <OFST> on the
service label.
10) Start service mode, and set '1' to the
following to enable potential control:
COPIER>OPTION>BODY>PO-CNT.
11) Check to make sure that the data lamp
in the control panel is off; then, turn off
the main power switch.
12) Disconnect the power plug from the
power outlet.
13) Remove the checking electrode from
the potential sensor.
14) Mount the potential sensor.
4-60 P
COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000