Shift Cable - Arctic Cat PROWLER HDX 2015 Service Manual

INSTALLING
1. Install the shift axle supports onto the shift lever;
then secure the axle supports to the frame with four
cap screws and tighten to 48 in.-lb.
2. Secure the shift cable end to the shift arm stud with
the cap screw and nut. Tighten to 8 ft-lb.

Shift Cable

REMOVING
1. Remove the dashboard (see Dashboard in this sec-
tion).
2. Remove the nut securing the shift cable to the shift
arm stud; then loosen the upper adjuster nut on the
shift cable and remove the shift cable from the shifter
assembly.
HDX168A
3. Tilt the cargo box back and remove the E-clip from
the shift arm on the transmission; then loosen the
adjuster nut on the shift cable housing and remove
the shift cable from the transmission.
HDX168
4. Remove the center floorboard and remove all nylon
ties securing the cable housing to the frame; then
remove the shift cable.

NOTE: If the cable is being replaced, connect the
new cable to the end of the cable being removed and
pull the new cable into place.
HDX166A
HDX178A
HDX137B
27