Shift Lever/Shift Cable (Xtx) - Arctic Cat PROWLER XT 2014 Service Manual

ADJUSTING SHIFT CABLE
To adjust the shift cable, use the following procedure.
1. Set the parking brake; then remove the seats and cen-
ter console.
2. Make sure the shift lever is in neutral; then remove
the E-clip securing the cable end to the shaft arm.
3. Loosen nuts (A) and (B) and adjust the cable housing
to align the shift cable end to the shift arm stud (C).
14
PR571
4. Install the E-clip; then tighten the nuts (A) and (B)
securely.
5. Check each gear shift position for proper gear selec-
tion and make sure the proper icon illuminates on the
LCD; then install the center console and seats.
Shift Lever/Shift Cable
CHECKING
Turn the ignition switch on; then shift the transmission into
park. The letter P should illuminate on the LCD gauge and
the park icon (P) should illuminate. The vehicle should not
be able to move.
PR567A
Move the shift lever all the way to the rear. The letter L
should illuminate on the LCD gauge.
PR568A
(XTX)
PR572A
HDX203
HDX199