Hardware Settings - Fujitsu primergy TX150 User Manual

■ Cautions for Installing a Memory Module
This server supports up to 8GB of memory. However, the maximum installable size varies depending on
the OS. Furthermore, since the server uses part of the memory as PCI resources, the maximum available
size is limited.
The following shows the maximum installable size and the maximum available size.
OS
Windows 2000 Server
Windows Server 2003 / R2
SBS 2003
Windows Server 2003 x64 / R2 x64
*1:0.25GB is used as PCI resources.
For Windows Server 2003, Standard Edition, available memory size can be same as the installed memory if
Service Pack 1 is applied to and the following setting is configured using the BIOS Setup Utility.
1. Start the BIOS Setup Utility.
2. Select the [Advanced System Configuration] submenu from the [Advanced] menu.
3. Set [NX Memory Protection] to [Enabled].
■ LAN Cable
Be sure to connect the LAN cable when the server is not connected to the Internet.
Connecting to the Internet during setup can cause security problems. Do not connect to the Internet
until the setup completes.
If the OS is installed or applications are automatically installed without connecting the LAN cable to the
LAN card, an error may be recorded in the event viewer after setup completes.

2.1.2 Hardware Settings

Before starting installation, set necessary hardware, such as the BIOS Setup Utility.
■ BIOS Setup Utility
The BIOS Setup Utility must be set in the following cases. For details on how to set the BIOS Setup
Utility, refer to "8.2 BIOS Setup Utility" ( pg.217).
●
Changing the Boot Drive
To change the boot drive, start up the BIOS Setup Utility, select [Boot Option], and set the boot drive.
"8.2.4 Boot Options Submenu" (pg.222)
●
Performing Remote Installation
Before performing remote installation of ServerStart, use the following procedures to enable network
startup (PXE). In addition, check the MAC address.
table: Maximum Installable Size and Maximum Available Size
Installed memory
size
3.5GB or smaller
4.0GB or larger
Installed memory size
PRIMERGY TX150 S4 User's Guide
Available memory size
Same as the installed memory size
Installed memory size - (0.25GB)
Same as the installed memory size
2
*1
45