Fujitsu primergy TX150 User Manual page 265

■ Trouble during OS Installation
●
Automatic logon fails during Windows 2000 setup.
During OS installation, ServerStart installs applications and hardware utilities supplied with the OS.
Installation and subsequent restart and logon are performed automatically as necessary. In rare cases,
however, automatic logon is not performed and the logon window appears. In this window, use the user
name and password you have set before starting installation. After logon, the setup procedures are
continued.
■ Error Messages during Installation
The following error messages may appear during installation using ServerStart. Check the corrective
action against the relevant error.
●
"WzDiskAdmin: System Error! ......................, Last Error: The device is not
ready." appears
Optional SCSI devices (e.g., hard disk cabinet, MO disk unit, or DAT unit) may be connected.
Disconnect the optional SCSI devices and perform installation again. Connect the optional devices after
the installation completes.
●
"Operating System not found" appears when the system restarts after file
copy from the CD-ROM
The following are possible causes. Please check.
• The array controller card comes later than the onboard SCSI in order of device startup.
• The Active flag is specified.
●
"Missing Operating System" appears during installation
The installation partition size may be too large. Specify the installation partition size correctly.
For details on the installation partition size, refer to "2.3.1 Installation Partition Size" ( Pg.48).
●
"Error 1920. Service (PXE Services) failed to start" appears during
preconfigured installation
The system installed with the preconfigured settings (PXE server) may not be connected to the network.
Check the LAN cable connection and click [Rerun].
PRIMERGY TX150 S4 User's Guide
9
265