Hardware Settings - Fujitsu Primergy RX100 S2 User Manual

2.1.2 Hardware Settings

Before starting installation, set up necessary hardware configurations using the BIOS Setup Utility.
■ BIOS Setup Utility
The BIOS Setup Utility must be set in the following cases. For details on how to set the BIOS Setup
Utility, refer to "8.2 BIOS Setup Utility" ( pg.191).
●
Performing Remote Installation
Before performing remote installation of ServerStart, use the following procedures to enable network
startup (PXE). In addition, check the MAC address.
1
Take the following steps in the BIOS Setup Utility.
1. Start the BIOS Setup Utility.
"8.2.1 Starting and Exiting the BIOS Setup Utility" (pg.191)
2. Select the [PCI Configuration] submenu from the [Advanced] menu, then [Ethernet
on Board]. Press the [Enter] key.
The [Ethernet on Board] submenu window appears.
3. Set the following items to [Enable].
• When using LAN connector A:
[Option ROM Scan] of [PCI Device, Embedded Ethernet A].
• When using LAN connector B:
[Option ROM Scan] of [PCI Device, Embedded Ethernet B].
■
" Ethernet on Board Submenu" ( pg.203)
4. From the [Exit] menu, select [Save Changes & Exit] to exit the BIOS Setup Utility.
5. Start the BIOS Setup Utility again.
6. Select the [Boot Option] submenu from the [Main] menu. Press the [Enter] key.
The Boot Option submenu window appears.
7. Change the [Boot Sequence] setting as shown below.
1 IBA GE Slot 0208 v1217 (when LAN connector A is
used)
IBA GE Slot 0430 v1217 (when LAN connector B is
used)
2 CD-ROM
3 Removable Device
4 Hard Drive
8. Exit the BIOS Setup Utility and turn off the server.
2
Check the MAC address.
After BIOS setup, start up the server from the network.
The MAC address is displayed as shown below.
CLIENT MAC ADDR: ** ** ** ** ** **
The MAC address is required for remote installation. Write it down.
PRIMERGY RX100 S2 User's Guide
1
2
3
4
5
6
7
8
9
41