Fujitsu primergy TX150 User Manual page 93

Starting the DHCP Service
Installing ServerStart
Checking Services
Setting TFTP
Preparation of Resources
■ Starting the DHCP Service
Check that the DHCP service is running on the same network.
If the DHCP service function is not installed, perform the following procedures to install the DHCP
service. The following procedures are examples for Windows Server 2003.
1
Click [Start] → [Control Panel] → [Add or Remove Applications].
2
Click [Add or Remove Windows Components]. Click the [Dynamic Host
Configuration Protocol (DHCP)] service from [Network Services].
The DHCP service is installed.
3
Create and configure a DHCP scope so that the IP address can be distributed.
PRIMERGY TX150 S4 User's Guide
3
93