Starting Os Installation - Fujitsu primergy TX150 User Manual

Chapter 3 OS Installation Using ServerStart

3.2.4 Starting OS Installation

Install the OS to the server using the created configuration file.
During installation, do not use the mouse or keyboard unless it is necessary for installation operations.
Otherwise, installation may fail.
1
Turn on the server and insert the ServerStart Disc 1 CD-ROM immediately.
A message prompts you to insert the ServerStart floppy disk.
2
Insert the ServerStart floppy disk containing the created configuration file and
click [OK].
The [Initializing ServerStart] window appears and the ServerStart initialization process starts.
Depending on the hardware configuration, this process may take a few minutes. When
initialization is completed, the [ServerStart Unattended Mode] window appears.
3
Click [Start].
Installation starts.
1. When RAID has been configured, the system restarts.
2. If a message prompts you to insert the SCSI Array Controller Document & Tool CD
V6.0L10, insert the CD-ROM and click [OK].
3. If a message prompts you to insert the ServerView CD-ROM, insert the
PRIMERGY Document & Tool CD and click [OK].
This message does not appear when the PRIMERGY Document & Tool CD has been
inserted already.
80
Set the ServerStart floppy disk in the write-enabled state. If it is write protected, installation will
fail.