Restoring The System; For Windows Server 2003 - Fujitsu primergy TX150 User Manual

Chapter 9 Operation and Maintenance

9.6 Restoring the System

In the unfortunate event where the system file, system configuration, or environment
changes during startup are corrupted, use the repair information stored on the
recovery disk created at the installation to restore the system.
Create a recovery disk when you have installed an OS or changed the system configuration. Refer to
"5.2 Creating a Disk for System Recovery" ( Pg.152).

9.6.1 For Windows Server 2003

●
Items Required
• Windows Server 2003 CD-ROM
• Automated System Recovery (ASR) floppy disk (created beforehand)
• Backup media (created beforehand)
• Driver disk (for onboard SCSI controller / for SCSI array controller card)
For details about required driver disk and how to create a drive disk, refer to "4.1 Creating Driver
Disks" ( Pg.114).
1
Turn on the server and insert the Windows Server 2003 CD-ROM immediately.
Check there are no floppy disks in the floppy disk drive.
2
When the active area is specified on the hard disk, the following message
appears. Press any key while this message is displayed.
Press any key to boot from CD....
Setup window for Windows Server 2003 x64 appears.
3
The following message appears at the bottom of the window. Press the [F6]
key.
Press F6 if you need to install a third party
SCSI or RAID driver ...
4
When a message prompts you to press the [F2] key, press the [F2] key.
A message prompts you to insert the ASR floppy disk.
5
Insert the ASR floppy disk and follow the window instructions.
282
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.