Fujitsu primergy TX150 User Manual page 36

Chapter 1 Overview
3
Shut down the OS.
In the following cases, the server is turned off after the OS is shut down (Step 4 is not necessary).
• Windows OS
• ServerView is installed
In other cases, make sure that the access LEDs of floppy disk and hard disk are off when the OS
is shut down.
4
Press the power switch on the front of the server.
The server's power LED is lit amber.
5
Turn off the display and peripheral devices.
The time to turn the server off can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView. For details, refer to
■ Cautions when Turning the Power Off (When the OS is Windows
Server 2003 or Windows 2000 Server)
• For Windows Server 2003
"Do Nothing", "Prompt Input", "Standby", "Hibernation", or "Shutdown" can be specified as the
operating mode of the power switch in the OS settings (normally, "Shutdown" is specified).
• For Windows 2000 Server
"Standby", "Hibernation", or "Power Off" can be specified as the operating mode of the power switch
in the OS settings (normally, "Power Off" is specified).
On this server, functions corresponding to "Standby" and "Hibernation" are supported as BIOS and
hardware functions. However, some drivers and software installed in the server do not support these
functions. For this reason, functions corresponding to "Standby status" and "Hibernation status" are
unavailable on this server.
When the operating mode is set to "Standby" or "Hibernation", the system may operate improperly or
hard disk data may be corrupted. For details about operating mode settings, refer to the OS manual.
36
The servers power
LED is lit amber
• Be sure to wait for 10 seconds or more after shutdown before turning the
server on.
3.2 Settings for Server Monitoring
"
in ServerView User's Guide.
" " "