Fujitsu primergy TX150 User Manual page 128

Table of Contents

Advertisement

Chapter 4 Manual OS Installation
2
Turned on the server and configure RAID. If RAID is not required to be
configured, proceed to step 3.
Turn off the server after configuring the array system.
To configure the array system with onboard SCSI array controller
Turn on the server to display the following message and press the [Ctrl] + [C] key to start up the
SCSI Setup Utility.
Press Ctrl-C to start LSI Logic Configuration Utility
RAID 1 is configured. For more details, refer to "8.3.6 Configuring and Deleting the Array
System" ( pg.245)
To configure the array system with SCSI array controller card (PG-140D1)
Turn on the server to display the following message and press the [Ctrl] + [H] key to start up the
WebBIOS.
Press <Ctrl><H> for WebBIOS
The array system is configured by using WebBIOS. For more details, refer to the manual which
comes with the SCSI array controller card.
3
Prepare the Windows 2000 Server CD-ROM.
Turn on the server and insert the Windows 2000 Server CD-ROM immediately into the CD-ROM
drive. Check there are no floppy disks in the floppy disk drive. When the active area is specified
on the hard disk, the following message appears.
Press any key to boot from CD....
Pressing any key while this message is displayed boots the system from the CD-ROM.
4
The [Windows 2000 Server Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
Press F6 if you need to install a third party SCSI or RAID
driver ...
5
Install the Drivers for onboard SCSI controller or SCSI array controller card
manually.
1. When the following message appears, press the [S] key.
To specify additional SCSI adapters, CD-ROM drives, or
special disk controllers for use with Windows 2000,
including those for which you have a device support disk
from a mass storage device manufacturer, press S.
128
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents