Hardware Settings - Fujitsu PRIMERGY RX300 S3 User Manual

Chapter 2 Checking before OS Installation

2.1.2 Hardware Settings

Before starting installation, set necessary hardware, such as the BIOS Setup Utility.
■ BIOS Setup Utility
The BIOS Setup Utility must be set in the following cases. For details on how to set the BIOS Setup
Utility, refer to "8.1 BIOS Setup Utility" ( pg.228).
●
Changing the Boot Drive
To change the boot drive, start up the BIOS Setup Utility, select [Boot Option], and set the boot drive.
"8.1.4 The Boot Options Submenu" (pg.233)
●
Performing Remote Installation
Before performing remote installation of ServerStart, use the following procedures to enable network
startup (PXE). In addition, check the MAC address.
1
Take the following steps in the BIOS Setup Utility.
1. Start the BIOS Setup Utility.
"8.1.1 Starting and Exiting the BIOS Setup Utility" (pg.228)
2. Select [Boot Options] and press the [Enter] key.
The Boot Options menu window appears.
3. Change [MultiBoot for HDs] to [Enabled].
4. Press the [Esc] key and select the [Advanced] menu.
5. Select the [Peripheral Configuration] submenu and change [LAN Remote Boot
Ch.A] to [PXE].
"8.1.6 The Peripheral Configuration Submenu" (pg.236)
6. Press the [Esc] key. Select [Save Changes & Exit] from the [Exit] menu to exit the
BIOS Setup Utility.
7. Start the BIOS Setup Utility again.
8. Select the [Boot Option] submenu from the [Main] menu. Press the [Enter] key.
The Boot Option submenu window appears.
9. Change the [Boot Sequence] setting as shown below.
1 BootManage PXE, Slot 0500
2 CD-ROM
3 Removable Device
4 Hard Drive
10. Exit the BIOS Setup Utility and turn off the server.
44