Mounting On A Din Rail; Replacing Existing Fastrack Supreme Or Fastrack Xtend Device - Sierra Wireless FX30S User Manual

Sierra Wireless FX30S User Guide
For this orientation, attach one DIN
rail clip to the side of the bracket.
Rev 2 Mar.18

Mounting on a DIN Rail

To mount the FX30S in a DIN rail:
1. Attach the DIN rail clips to the bracket as shown in
If you are mounting the FX30S on its edge, attach one DIN rail clip to the side
of the bracket.
If you are mounting the FX30S horizontally or vertically, attach two DIN rail
clips to the bottom of the bracket.
For these orientations, attach two DIN rail clips to the bottom of the bracket.
Figure 2-8: Attaching the DIN rail clips
2. Slide or snap the FX30S onto the bracket, as shown in
3. If the DIN rails are in a high vibration environment, see
in a High Vibration Environment
4. Attach the FX30S to the DIN Rail. See
Replacing existing Fastrack Supreme or
Fastrack Xtend Device
If you are going to be mounting the FX30S in a location where you previously had
a Fastrack Supreme or a Fastrack Xtend mounted, attach the compatibility bar to
the bracket. The compatibility bar is available from Sierra Wireless.
Note: Adding the compatibility bar does not change the height of the gateway + mounting
bracket. See Figure 3-4 on page 55.
16
Figure
Figure
Optional—Mounting
on page 14.
Figure 2-8.
2-8.
2-4.
41110485