Mounting On A Din Rail; Replacing Existing Fastrack Supreme Or Fastrack Xtend Device - Sierra Wireless Octave FX30S User Manual

Mounting on a DIN Rail

To mount the FX30S in a DIN rail:
1. Attach the DIN rail clips to the bracket as shown in
For this orientation, attach one DIN
rail clip to the side of the bracket.
2. Slide or snap the FX30S onto the bracket, as shown in
3. If the DIN rails are in a high vibration environment, see
4. Attach the FX30S to the DIN Rail. See
Replacing Existing Fastrack Supreme or Fastrack
Xtend Device
If you are mounting the FX30S in a location where you previously had a Fastrack
Supreme or a Fastrack Xtend mounted, attach the compatibility bar to the bracket. The
compatibility bar is available from Sierra Wireless.
Note: Adding the compatibility bar does not change the height of the gateway and mounting
bracket. See
Rev. 5 September 2020
If you are mounting the FX30S on its edge, attach one DIN rail clip to the side of the
bracket.
If you are mounting the FX30S horizontally or vertically, attach two DIN rail clips to the
bottom of the bracket.
For these orientations, attach two DIN rail clips to the bottom of the bracket.
Figure 2-8: Attaching the DIN rail clips
Vibration Environment on page 15.
Figure 3-4 on page 48.
Figure
Figure 2-8.
17
Installation and Startup
2-8.
Figure 2-4.
Optional—Mounting in a High
41110485