Table of Contents
Advertisement
Check that the fork of the new connecting link fork has
an O-Ring installed on each pin.
Insert the new connecting link fork from the wheel side,
avoiding any contact with the pins in order not to remo-
ve the lubricant.
Place the other two O-Rings on the extended ends of
the bushings.
Rotate the rear wheel so that the rivet link is positioned
F
on the lower strand of the chain where there is more
room to work.
Closing the rivet link
Closing the link utilising the special tool.
Special tool no. 8000B1456.
Put the assembling tool on the chain, placing the cen-
tering pin between the chain rollers, in order to fit with
the rivet link.
Thread the bolt (1) with the fingers in until the outer
plate is placed on the rivet link fork pins.
With a wrench fully thread in the bolt (1) until the pin
ends reach the bottom the slots in the link plate carrier
(2). Avoid to force too much. This places the outer plate
at the correct position on the fork.
Slowly unscrew the bolt (1) and remove the tool from
the chain.
Suspension and wheels
- 52 -
2
1
1
Advertisement
Table of Contents
