BRAKE PADS
Wear check / substitute ¨
Check the condition and thickness of the brake pads
on the calipers.
Measure the thickness of the pad linings. If the thick-
ness of the linings is equal to or less than the wear limit
shown below, replace the pads as described in chapter
H "Brakes".
Wear limit: 1 mm
If the brake pads are substituted, it is nec-
essary to effectuate a proper running-in
period before reaching an optimal braking
efficiency.
THROTTLE CONTROL
Throttle control play check¨ At the pre-delivery check,
The throttle control should not be too tight or too slack
(excessive play) in its movement.
It must also be free of play and looseness when turning it.
For optimum adjustment it is necessary to work on the
two upper nut adjusters (situated on the throttle control
handgrip).
The lack of play on the closure of the throt-
tle control (1) can stop the complete closing
of the throttle valve and the throttle control
could remain in the open position, thereby
leaving the engine with a fast tickover.
Maintenance
Maintenance
At the first 1000 kilo-
metres and then every
6000 kilometres
at the first 1000 kilome-
tres and then every 6000
kilometres.
- 49 -
Front brake caliper
Rear brake caliper
B
Disc
Pads
Wear limit 1 mm
1