MV Agusta F4 1000 Workshop Manual page 70

Hide thumbs Also See for F4 1000:

Table of Contents

At the first 1000 kilometres and then

every 6000 kilometres.

To adjust the chain tension, proceed as follows:

Slightly slacken the two screws of the rear wheel hub.

Loosen the 2 rear wheel hub screws.

Using the special spanner as indicated in the figure,

move the eccentric adjuster nut backwards or forwards

respectively slackening or tightening the chain, until

the correct play is reached (as described previously).

Successively tighten the screws of the rear wheel hub

to the torque pressure indicated as follows:

Tighten the screws to the specified torque

in several steps and in an alternate pattern.

Rear hub eccentric adjuster screw torque

pressure: 28 ÷ 32 N·m

Grease only the first threads.