Checking The Level Of The Rear Brake Fluid; Substitution And Bleeding Of The Brake/Clutch Fluid - MV Agusta F4 1000 Workshop Manual

Checking the level of the rear brake fluid

No parts of the vehicle need to be removed from the
vehicle to check the level of the rear brake fluid.
B
If the fluid is below the low level mark, follow these
steps to top up with brake fluid complying with the spec-
ifications:
remove the saddle and the fuel tank;
remove the 2 screws from the reservoir cap;
remove the three cap elements.
Pour fresh fluid until it reaches the prescribed level in
the reservoir.
Recommended brake fluid: AGIP DOT 4 or
equivalent.
Do not use brake fluid that comes from old
containers, has already been used or does
not come from a sealed container. Do not
use brake fluid that is left over from previ-
ous maintenance or stored for long periods.
Utilise only the recommended brake fluids.
Follow a similar procedure to the one used for the front
brake fluid reservoir.

Substitution and bleeding of the brake/clutch fluid

The substitution of the brake/clutch fluid and the suc-
cessive bleeding of the circuit are operations that
require particular caution and precision.
To carry out these operations, it is therefore necessary
to follow the procedure described in chapter H
"Brakes" of this manual.
Maintenance Maintenance
- 46 -