Table of Contents
Advertisement
Rear shock absorber support plate removal
Remove the three screw (1) indicated in the figure and
remove the support plate (2).
When reassembling, it is necessary to apply special
product to the three screws and lightly screw them in.
Tighten the central screw first and then the other two to
the prescribed torque pressure.
Special product: Loctite 243
Torque pressure: 40 ÷ 44 N·m
Compensator Assembly
Replace the rocker unit components in the sequence
shown in the figure.
Pay attention to position both plastic spacers on the left
side of the motorcycle.
Suspension and wheels
- 43 -
1
2
F
40÷44 N•m
Advertisement
Table of Contents
