Table of Contents
Advertisement
Screw in and tighten the three screws (1) at the base
of the steering.
Carry out this assembly correctly. A casual or
inexact assembly could compromise the sta-
bility and steering of the motorcycle.
Fit the right-hand leg following a similar procedure.
Tighten the three screws (1) at the base of the steer-
ing. Effectuate the operation several times until the
torque wrench does not turn the screw any more.
This operation must be carried for both stems.
Grease only the first threads.
Torque pressure: 8 ÷ 9 N·m
Ensure that the steering head is sitting perfectly in its
seat. Tighten the two screws (2) of the steering
head/stems to the prescribed torque pressure and suc-
cessively tighten the central screw (3).
Torque pressure steering head (2):
16 ÷ 18 N·m
Torque pressure central screw (3):
22 ÷ 24 N·m
Grease only the first threads.
This check is necessary for the correct
positioning of the stems even if the steering
head has not been removed. This check
guarantees the standard set-up of the
motorcycle.
Suspension and wheels
- 21 -
1
8÷9 N•m
1
16÷18 N•m
2
F
22÷24 N•m
3
Advertisement
Table of Contents
