Table of Contents
Advertisement
How to select the mapping of the control unit
It is possible to select special mapping on the control
unit of the F4 1000 model which allows you to obtain
higher power and performance characteristics for deci-
B
dedly sporty use of the vehicle.
The mapping of the control unit can be selected by
pressing the start button when the engine is switched
on. "SPORT" appears on the dashboard display to
show the mapping has been selected.
WARNING
Control unit mapping selection operations
must be carried out with the engine running
on neutral, with the motorcycle stopped
with the stand on the ground. Changing
display settings while running is prohibited.
Error / malfunction messages
The dashboard can signal a fault or malfunction during
different motorcycle use conditions.
- Engine start-up: Turning the ignition switch to "ON",
the instrumentation and indicators run diagnostic
tests. When a vehicle fault is present, the display will
show an error message as shown in the figure to the
side. In particular, the motorcycle unit or component
where the malfunction was detected is highlighted.
Maintenance
- 76 -
Advertisement
Table of Contents
