Table of Contents
Advertisement
REAR BRAKE CALIPER SUBSTITUTION
To facilitate the operation, remove the brake pads as
described previously.
Empty the rear brake system as previously described
in the paragraph "SUBSTITUTION AND BLEEDING
OF THE REAR BRAKE FLUID".
Remove the tubing by unscrewing the union indicated
in the figure.
Pay attention to the fluid left in the caliper and the tube.
Remove the two screws indicated in the figure.
Substitute the caliper.
For reassembly, tighten the two screws to the pre-
scribed torque pressure.
Recommended threadlocking product:
Loctite 243
Torque pressure: 18 N·m
H
Assemble the union tightening to the prescribed
torque.
Torque pressure: 16-18 N·m
NOTE
Substitute the gaskets with new ones.
Proceed with the filling and bleeding of the rear brake
system (see page 20).
Brakes
18 N•m
16÷18 N•m
- 22 -
Advertisement
Table of Contents
