Table of Contents
Advertisement
Suspension and wheels
Extract the spacer from the right side.
Check the condition of both bearing seats and the seat
of the spacer.
If the spacer is in good condition, reinsert it onto the
fork from the right side.
Fitting the bearings and the roller cases on the rear
F
swingarm.
Take two new roller cases (Part No. 800084936) and
two new ball bearings (Part No. 800084938).
Preassemble the 2 roller cases (Part No. 800084936)
on specific tool Part No. 800092866 (see figure).
Fit the assembly to the left side of the swingarm.
Assembly the inner bearing spacer (Part No.
800084872) and the two ball bearings (Part No.
800084938) on the tool Part No. 800092866 on the
right side of the swingarm (see figure).
Complete the assembly by fitting the two bushings
relating to the tool Part No. 800092866 on the right
side of the swingarm.
Special tool no. 800092866
- 57 -
Advertisement
Table of Contents
