Operations; Control Panel - GRAPHTEC CE5000-40CRP Service Manual

3. OPERATIONS

3.1 Control Panel

PAUSE .......Press this function key once in READY status to switch to PAUSE status in order to change
the various settings. Press it again to cancel the PAUSE status. Pressing this key while
cutting or plotting is in progress stops the cutting or plotting.
ENTER ......Pressing this function key registers the cutting or plotting conditions set.
POSITION .These keys are used to move the cursor or change the settings on the LCD display on the
function setting screens. Press these keys when in PAUSE status to move the pen carriage
or the medium.
ORIGIN ......Press this function key to set the origin point. The pen position is set as the origin point when
this key is pressed.
CE5000-UM-251-9370
Indicator Lamp
STATUS .....Illuminates while the power to the cutting
plotter is turned on, and goes out when
the cutting plotter is in PAUSE status.
This lamp flashes when data is being
received from an interface, regardless
of whether or not the cutting plotter is in
PAUSE status.
Panel Keys
TEST ..........Press this function key to conduct
a cutting test and check the cutting
conditions.
PREV. ........Press this function key to view the
previous display on the LCD when in
PAUSE status.
NEXT .........Press this function key to view the next
display on the LCD when in PAUSE
status.
COND. .......Press this function key to view the cutter-
pen condition settings.
3-1
3. OPERATIONS