Adjusting The Offset Of The Auto-Registration Mark Sensor - GRAPHTEC CE5000-40CRP Service Manual

7.9 Adjusting the Offset of the Auto-Registration Mark Sensor

If you have the auto-registration mark sensor option, you must adjust the offset of the auto-registration mark
sensor.
How to set the auto-registration mark sensor option
(1) Load an A4 (Letter) or larger size sheet of paper in the plotter. The paper must have a printed target
cross mark. (Print out the target sheet (see page 7-12) on a printer.) The specifi cation of the cross mark
is 30 mm line length, and 0.3 to 0.5 mm line width.
(2) Mount a water-based ballpoint pen in the plotter.
(3) Turn on the power while pressing the TEST and ENTER keys.
(4) Select the media mode.
(5) Set the plotting conditions to the following settings:
Force: 12, Speed: 40, Quality: 1, Tool: Pen
(6) Press the PAUSE key to display the menu shown below.
MODEL SELECT
(7) Press the NEXT key until the following menu is displayed.
MARK SENS POS
(8) Press the ENTER key to display the menu shown below.
MARK ADJ SCAN
(9) Use the Position keys to move the pen position to the printed cross mark area shown below.
Printed target mark
(10) Press the ENTER key to scan the printed cross mark. The plotter then plots a new cross mark based on
the reading of the printed cross mark.
The following menu is displayed.
X=00.0 Y=00.0
CE5000-UM-251-9370
Media feed
direction
10 mm
Move the pen position into this area.
7-10
7. ELECTRICAL ADJUSTMENTS